Practical plumbing, HVAC, and electrical advice from a team with 15+ years of experience in the Pikes Peak region. Real guidance you can use — no fluff.
Clearing a blockage typically runs $200 to $600. A full replacement can run $20,000. The gap is why you should never authorize a dig without seeing camera footage of your own line first.
Read more →Standard-efficiency AC systems typically run $5,000 to $9,500 installed in our market. Why it is quoted as a matched system, what altitude and dry air change, and why the top efficiency tier rarely pays back in a short cooling season.
Read more →Standard-efficiency furnaces typically run $3,500 to $6,000 installed here, high-efficiency $6,000 to $10,000. What moves that number, why the BTU on the box is not what you get at 6,035 feet, and when a repair is enough.
Read more →Leaking tank, or leaking fitting? Eight years old, or twelve? A straight decision guide for when a water heater is worth fixing and when it is time to swap it out.
Read more →Gas tankless typically runs $3,000 to $5,500 installed in our market. Here is what drives that number, why altitude means sizing up, and the households where a tank is still the better buy.
Read more →An installed softener typically runs $1,500 to $3,000 where a soft-water loop already exists. What our hard water actually costs you, and the cheaper steps worth trying first.
Read more →Most residential gas work is a short run at the inexpensive end of the trade. What actually sets the price is pipe sizing, and why adding a tankless unit can change the whole system.
Read more →Trenchless replacement typically runs $4,000 to $9,000 here, and frost depth is a big part of why. Plus the 45-minute meter test that tells you whether you need one at all.
Read more →Swapping a pump in an existing pit typically runs $400 to $900, cutting in a new pit $1,500 to $4,000. Plus the reason a lot of wet basements here are a gutter and grading problem.
Read more →Standard-efficiency boilers typically run $6,000 to $10,000 installed, condensing units $9,000 to $16,000. Why most no-heat calls are a part rather than the boiler, and what altitude changes about the setup.
Read more →A like-for-like panel swap typically runs $1,500 to $3,000 and a 100 to 200 amp service upgrade $2,500 to $5,000. How to tell whether you need the upgrade or just a subpanel.
Read more →Clearing a single fixture drain typically runs $150 to $350, a main line $200 to $600. The cheap things worth trying first, and why most sewer scares end as a cleaning.
Read more →Altitude changes how your furnace and AC perform. Learn why systems lose efficiency above 6,000 feet and what Colorado Springs homeowners should know about proper sizing and maintenance.
Read more →At 6,035 feet, Colorado Springs gets temperature swings that catch homeowners off guard. Here is what actually works to protect your pipes when it drops below zero.
Read more →A straightforward breakdown of water heater installation pricing in Colorado Springs — tank vs tankless, what affects cost, and what you should actually expect to pay in 2026.
Read more →Whether it's plumbing, HVAC, or electrical — our Colorado Springs team is ready. Most jobs start within 24 hours.
Book Your Service →